8F /0         POP m16                 Pop top of stack into m16; increment stack pointer

8F /0         POP m32                 Pop top of stack into m32; increment stack pointer

58+ rw         POP r16                 Pop top of stack into r16; increment stack pointer

58+ rd         POP r32                 Pop top of stack into r32; increment stack pointer

1F         POP DS                 Pop top of stack into DS; increment stack pointer

07         POP ES                 Pop top of stack into ES; increment stack pointer

17         POP SS                 Pop top of stack into SS; increment stack pointer

0F A1         POP FS                 Pop top of stack into FS; increment stack pointer

0F A9         POP GS                 Pop top of stack into GS; increment stack pointer


Description

Loads the value from the top of the stack to the location specified with the destination operand and then increments the stack pointer. The destination operand can be a general-purpose register, memory location, or segment register.


The address-size attribute of the stack segment determines the stack pointer size (16 bits or 32 bits—the source address size), and the operand-size attribute of the current code segment deter-mines the amount the stack pointer is incremented (2 bytes or 4 bytes). For example, if these address- and operand-size attributes are 32, the 32-bit ESP register (stack pointer) is incre-mented by 4 and, if they are 16, the 16-bit SP register is incremented by 2. (The B flag in the stack segment's segment descriptor determines the stack's address-size attribute, and the D flag in the current code segment's segment descriptor, along with prefixes, determines the operand-size attribute and also the address-size attribute of the destination operand.)


If the destination operand is one of the segment registers DS, ES, FS, GS, or SS, the value loaded into the register must be a valid segment selector. In protected mode, popping a segment selector into a segment register automatically causes the descriptor information associated with that segment selector to be loaded into the hidden (shadow) part of the segment register and causes the selector and the descriptor information to be validated (see the "Operation" section below).


A null value (0000-0003) may be popped into the DS, ES, FS, or GS register without causing a general protection fault. However, any subsequent attempt to reference a segment whose corre-sponding segment register is loaded with a null value causes a general protection exception (#GP). In this situation, no memory reference occurs and the saved value of the segment register is null.


The POP instruction cannot pop a value into the CS register. To load the CS register from the stack, use the RET instruction.


If the ESP register is used as a base register for addressing a destination operand in memory, the POP instruction computes the effective address of the operand after it increments the ESP register.


The POP ESP instruction increments the stack pointer (ESP) before data at the old top of stack is written into the destination.


A POP SS instruction inhibits all interrupts, including the NMI interrupt, until after execution of the next instruction. This action allows sequential execution of POP SS and MOV ESP, EBP instructions without the danger of having an invalid stack during an interrupt 1 . However, use of the LSS instruction is the preferred method of loading the SS and ESP registers.


Operands        Bytes                Clocks

reg                  1                   1   UV

mem               2+d(0-2)         3   NP

seg                  1                   3   NP

FS/GS                2                  3   NP


Protected Mode

CS/DS/ES             1                     3-12  NP

SS                   1                     8-17  NP

FS/GS                2                    3-12  NP


Flags

None.

Created with the Personal Edition of HelpNDoc: Create help files for the Qt Help Framework